SINGER 7050 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING THE NEEDLE THREADER (P)
To help in threading the machine needle, use the needle threader as follows:
• Thread machine and draw 4" (10 cm)
of thread down to the needle.
• Lower presser foot lifter.
• Holding needle threader as shown with
your right hand, position U-shaped part
of threader under bar of needle clamp.
• Snap threader up onto bar.
• Swing threader back just far enough to clear
the needle.
• Slide threader as far to the left as it will
go.
• Be sure guide (1) is against the left side
of the needle.
• Bring metal hook of threader forward,
through the eye of the needle.
• Holding 3" (7.5 cm) of thread between
your fingers, guide thread into metal
hook. Release thread.
• Holding threader with right hand, draw
metal hook and thread backwards
through eye of the needle.
• To remove needle threader, slide it to
the right, and off bar of needle clamp.
• Carefully unhook thread from needle
threader.