beautypg.com

Section 4: recording, 2) rec function-triggered recording, Notes – Tascam DA-38 User Manual

Page 8: Section 4 : recording, U-)?i

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

SECTION 4: RECORDING

(2) REC FUNCTION-triggered Recording

Suggestion

: Each time you start recording, that

point is automatically stored into memory, erasing the
previous one. You can program the DA-38 to punch in

at that point, as discussed later, page 4

• 7,

paragraph

(4).

7 To terminate recording, press STOP.

Suggestion

: Each time recording is stopped, that

point is automatically stored into memory, erasing the
previous one. You can program the DA-38 to punch

out at that point, as discussed later, page 4

• 7,

para­

graph (4).

• For the hookup, refer to a diagram shown in Section 1 if

necessary.

• Understand the Important Notices on the previous page.

• Adjust the mixer's level controls or the output level of

the source unit so high as possible without causing

overscale reading on the DA-38's meter.

• Perform steps 1 through 3 under the paragraph, Using

RECORD and PLAY.

When you have the DA-38 drop out of record to

rewind or fast-forward too, that point is saved.

Q

To prevent the tracks from accidentally erasing, press

the tracks' associated REC FUNCTION switches off.

NOTES

You cannot change the sampling rate when record­

ing is in progress.

if you start a new recording at the same time as the

tape format from the end of the existing recording

("assemble"), the tape is recorded and formatted at

the previous sampling rate. When preparing to

record from the end of the previous take and to

continue to format the tape, first rewind the tape to

a formatted silence section. Avoid starting record­

ing

and

formatting

from

a

non-recorded

and

unformatted blank section.

Then, follow these steps.

Y Making sure that all the REC FUNCTION switches

are released, hold RECORD and press PLAY. The

tape will start playing and the RECORD button will

start blinking.

2 Press the REC FUNCTION switch for the track(s)

you want to record on. The pressed REC FUNCTION

switches' associated LEDs will light solidly, and the

RECORD button the same.

u

-)?i

"3ns-

-dB

1

• If the tape is write-protected, the deck goes into

Play mode.

^

To stop recording, press STOP.

4*2