beautypg.com

3) auto input monitor, Notes, Note – Tascam DA-38 User Manual

Page 33

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

SECTION 9 : MONITOR AND OTHER CAPABILITIES

(3) Auto Input monitor

(4) Shuttle Monitor

This causes the inputs whose corresponding tracks are

record enabled to be sent directly to the same numbered

outputs whenever the transport goes into any other modes

than play.

3 2

1 4

When you rotate the SHUTTLE knob for reel rocking to

locate specific points on the tape, what you hear depends

on whether the shuttle monitor mode is activated or not, as

shown in the table below.

To activate this function :

To activate or disable the shuttle monitor function :

^

Press INSERT and the associated LED will light

solidly to show that the auto input mode is entered.

NOTES

As discussed above, if the DA-38 is not remote

controlled, the INSERT key switches on or off not

only the auto input monitor function but also the

Insert monitor function.

• When the INSERT LED is lit:

Both the insert and the auto input monitor modes

are activated.

When the INSERT LED Is turned off :

Both the insert and the auto input monitor func­

tions are disabled.

If you are using the optional RC-848 remote control

unit, you can switch the insert and the auto input

monitor functions on/off separately.

Y Press SHIFT and the associated LED will start blink­

ing to show that all the double function keys are

switched to offer their lower blue-labelled functions.

2 Press MENU as many times as necessary to access a

shuttle monitor menu which looks like "S

t L.n of F

".

^ Press either the A or the ▼ key to change the

' ' o f f "

to " on ".

H

M

S

F

S t

L.n

n

Shuttle Monitor
Mode

REC FUNCTION

Off

REC FUNCTION

On

51

L.

n o F F

(factory preset)

Tape

Tape

5 b L . n o n

Mute

Source

(Input)

NOTE

The shuttle monitor is not available unless both the

insert and the auto input monitor modes are acti­

vated.

^ Press SHIFT and the associated LED will turn off, the

display being switched back to show the ABS time,

• To disable the shuttle monitor mode, press either

the

A

or the

T

key at the shuttle monitor menu

to change the "o

n

" display to

"of F

9*2