Tascam DA-38 - Manual (Page 15)

SECTION 4: RECORDING
4-6. Postroll Time Setting
The DA-38 is factory preset to play for 3 seconds after
dropping out of record. You can change the time up to 59
minutes 59 seconds at a menu, in 1 second steps.
Out Point
Postroll Time
4-7. Copying Tracks
The DA-38 has a track matrix and you can assign any
sources (tracks or inputs as discussed below) to any loca­
tions, that is, to any tracks. So, for instance, you can
record input I on track 2 and copy track 8 to track 5,
simultaneously.
Here is an outline of the track copy procedure :
3 2
1 4
TRK COPY
4-
Target track selection (REC FUNCTION)
4
Source selection {▲ / t )
4
RECORD + PLAY
Y Press SHIFT and the associated LED will start blink­
ing to show that all the double function keys are
switched to offer their lower blue-labelled functions.
2 Press MENU to access a postroll menu, which looks
like this :
PRECAUTIONS
• When the track copy function is disabled
('t r.c P. oFF " as the dispay reads), you cannot
proceed to specify tracks or inputs.
• Even if a source and a target track are specified,
the track is not recorded unless the track's REC
FUNCTION switch is pressed on.
• Similarly, even if a source and a target track are
specified, the source is not fed to the track when
the track copy function is disabled ("t r.c P. oFF ").
H M s
F
Po.
n n
u u in
D
\ U D
2 Enter the desired postroll time using the A and T
keys.
^ Press SHIFT to exit the menu mode and switch the
display back to show the ABS time.
4*9