ClearOne AP400 - Manual (Page 58)

Appendices ~ Appendix E: Serial Commands 54
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
HOOKD
This command controls and reports the Hook Duration of the
unit.
[DEVICE] HOOKD
Explanation
X=1 Parameter to set Hook Duration to 50ms
X=2 Parameter to set Hook Duration to 500ms
X=Null Parameter to report back the current state
Return Values
The command returns the current hook duration of the unit in
the same format as the command. If the sent command
changes the hook duration of the unit, the updated hook
duration is returned.
LFP
This command locks, unlocks, or returns the current state of
the front panel from the serial port.
[DEVICE] LFP
Explanation
X=0 Parameter to unlock the front panel.
X=1 Parameter to lock the front panel
X=2 Parameter to toggle the state from one
state to the other (regardless of current
state)
X=Null Parameter to return the current state of the
front panel
Return Values
The command will return the updated condition of the front
panel.
LMO
This command changes or reports back the setting of the last
microphone on mode for each AP400.
[DEVICE] LMO
Explanation
X=0 Parameter to set the mode to OFF
X=1 Parameter to set the mode to Microphone
#1
X=2 Parameter to set the mode to Last
Microphone On
X=Null Parameter to return the current mode
Return Values
The command will return the updated mode for the selected
AP400 in the same format as the command.
LVL
This command reports back the level for a given channel.
[DEVICE] LVL
Explanation
CH= 1-4 Parameter to apply to the specified channel
CH= A-D, T Parameter to apply to the specified channel
W= I Parameter to specify an input meter
W= O Parameter to specify an output meter
W= A Parameter to specify an adaptive ambient
meter (channels 1-4 only)
Return Values
The command will return the input level of the channel in the
same format as the command.