YSI IQ SensorNet FDO Sensor User Manual
Page 14
3 - 2
ba76014e03
05/2014
Commissioning
FDO
®
70x IQ ...
Are the plug
connections dry?
Before connecting the sensor and sensor connection cable, please
make sure the plug connections are dry. If moisture gets into the plug
connections, first dry the plug connections (dab them dry or blow them
dry using compressed air).
Connecting the sensor
to the sensor
connection cable
Fig. 3-1
Connecting the sensor
Do not suspend the sensor on the sensor connection cable.
Use a sensor holder or armature. Information on this and
other IQ
S
ENSOR
N
ET
accessories is given in the YSI cata-
log and on the Internet.
1
Take the protective caps off the plug connections of the sensor
and the SACIQ (SW) sensor connection cable and keep them
safe.
2
Plug the jack of the SACIQ (SW) sensor connection cable onto
the plug head connector of the sensor. At the same time, rotate
the socket so that the pin in the plug head connector (1) clicks
into one of the two holes in the socket.
3
Then screw the coupling ring (2) of the sensor connection
cable onto the sensor up to the stop.
SACIQ
1
2