Compaq AA-RHGWB-TE - Manual (Page 195)

Figure 8–6: Cabling a Shared SCSI Bus with a TZ885
DWZZA-VA,
trilink connector,
and H879 terminator
DWZZA-VA
and trilink connector
Trilink
connector
and
H879-AA
terminator
AlphaServer 2100A
T
BA350
DWZZA-AA
TZ885
AlphaServer 2100A
BA350
adapters
T
Memory
Channel
ZK-1344U-AI
Memory Channel link cable
BN21K or BN21L cables
BN21K
or
BN21L
cable
T
BC19J
T T
H8574-A
terminator
1
2
3
4
1
2
3
4
5
5
KZPSA adapter,
trilink connector,
and H879 terminator
8.5 Preparing the TZ887 for Shared SCSI Bus Usage
The TZ887 Digital Linear Tape (DLT) MiniLibrary combines a cartridge tape
drive (TZ88) and an automatic cartridge loader. It uses a seven-cartridge
(CompacTape IV) removable magazine with a total capacity of nearly 280
GB compressed. It is capable of reading/writing at approximately 10.8 GB
per hour.
As with any of the shared SCSI devices, the TZ887 SCSI IDs must be set
to ensure that no two SCSI devices on the shared SCSI bus have the same
SCSI ID.
The following sections describe how to prepare the TZ887 in more detail.
8.5.1 Setting the TZ887 SCSI ID
The TZ887 SCSI ID is set with a push-button counter switch on the rear of
the unit (see Figure 8–7). Push the button above the counter to increment
the address; push the button below the counter to decrement the address
until you have the desired SCSI ID selected.
Configuring a Shared SCSI Bus for Tape Drive Use 8–15