Compaq AA-RHGWB-TE User Manual
Page 179
# /usr/sbin/setld -i | grep ATM
•
OSFATMBASE: ATM Commands
•
OSFATMBIN: ATM Kernel Modules
Additionally, after the ATM subsets have been installed, verify that a
new kernel has been built with the following kernel options selected
(/sbin/sysconfig -q atm):
•
Asynchronous Transfer Mode (ATM)
•
ATM UNI 3.0/3.1 Signalling for SVCs
•
LAN Emulation over ATM (LANE)
3.
Enable the ATM driver with the following command:
# /usr/sbin/atmconfig up driver=driver_name
In the command, driver_name is lta# for the ATMworks 350. The
number sign (#) is the adapter number.
To enable lta0 to initiate contact with the network, enter the following
command:
# /usr/sbin/atmconfig up driver=lta0
4.
Check the ATM switch for an indication that it is receiving idle cells.
The following table provides the indication for a few ATM switches. If
you do not have one of these switches, check the documentation for your
switch to determine how the switch indicates that it is cabled correctly.
ATM Switch
Indicator
Comments
Compaq GIGAswitch
PHY
Illuminated green LED indicates
that the switch is receiving idle
cells from the ATM adapter.
Bay Networks
®
Centillion100
En
Illuminated green LED indicates
that the switch is receiving idle
cells from the ATM adapter.
SynOptics
®
LattisCell
10114
Link
Illuminated green LED indicates
that the switch is receiving idle
cells from the ATM adapter.
CISCO
®
Systems
LightStream 1010
TX
The switch starts transmitting
data as soon as it receives idle
cells. The green TX LED will
flash on and off.
FORESystems
®
ForeRunner A S X200
TX
The Yellow TX LED will
be on steady.
Preparing ATM Adapters 7–5