beautypg.com

Viconics VWG-50 (Classic ZigBee) Design Consideration and Setup Guide User Manual

Page 3

background image

3 | VWG-50-Setup Guide

Ferrites supplied with the power supply and VWG MUST be installed according to
instructions. Failure to do so may void the FCC compliance of the VWG and wireless
controllers.

Only VWG-PS-DC and VWG-PS-AC power supply can be used with the VWG. The usage
of another non-approved power supply may void the FCC compliance of the VWG and
wireless controllers.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.

T

RADEMARKS

Niagara, Niagara AX is a registered trademark of Tridium, Inc.
LON, LonWorks™ and LonTalk™ are registered trademarks of Echelon™ ™ Corporation.
BACnet™ is a registered trademark of ASHRAE.

O

VERVIEW

The VWG-50 and related wireless controllers are targeted to retrofit
applications where the addition of communicating field bus wiring within
the building space is prohibitive. The Gateway and Communicating
Controllers with wireless field bus encourages the use of existing wiring
utilized by existing electronic controller type controls.

The VWG-50-XX-5000 when utilized in conjunction with the
VT7xxxXxxxxW series wireless controllers will offer the integrator simple
BACnet IP or BACnet MS/TP objects to integrate over standard building
automation systems using familiar integration toolsets.

A maximum of 50 wireless controllers can be wirelessly attached to a single VWG-50

The following additional documentation is available on

www.viconics.com

Gateway BACnet integration guide, is available in document ITG-VWG-50-BAC-Exx

 Information on VWG hardware installation is available in document LIT-VWG-50-

INSTALL-Exx