Viconics VWG-50 (Classic ZigBee) Design Consideration and Setup Guide - Manual (Page 26)

26 | VWG-50-Setup Guide
If a particular controller refuses to join the network and cannot be seen by the VWG.
Please move momentarily closer to the VWG until it has joined the network and it is added
to the database. It can then be re-located to its original position. This is necessary for it to
be assigned a Zigbee™ address to join the network.
Note: For more information on “orphan nodes” and Zigbee™ connectivity, please refer to
document: 028-0297_Rx_MAN VST5000W5000W-Exx.pdf
Adding Points
After the controllers have been added to the network, the next step is to add the points to
the BACnet export table of the VWG.
Select the required controllers from the database ( more than one can be selected ) and
click on the “Add Points” button. This will add all the points from each selected controller
in the “BACnet Points Viewer” tab.
“Match Button”
Used when replacing controllers or matching them in the field during the initial
commissioning. This feature allows you to match the characteristics of an offline created
database controller or an existing replaced one to a newly discovered one in the field
.