beautypg.com

Viconics VWG-50 (Classic ZigBee) Design Consideration and Setup Guide User Manual

Page 25

background image

25 | VWG-50-Setup Guide

Wireless Controller / Controllers Manager

This is where the wireless controllers are discovered and then added to the database
together with the associated points for each device.

Toolbar



Click on the “Discover” button and set the range of the com addresses. EX: (Discover
controllers in the range of com address from 1 to 100)

PLEASE NOTE: During the process of adding or removing “many” controllers at once, the
tool “may” not respond to new inputs while the process is active. Wait until the VWG has
finished processing the required modification before initiating any new commands. The
addition of 50 controllers in a database can take up to 10 minutes.

Note: During anytime a page loads, do not perform another command (re-click) or
re-call the same function twice. DO give time for the pages to remotely load
normally. Not doing so “can
” cause the system to hang or go down. If this happens,
a simple browser reboot will be necessary.

Also be sure to delete old controllers no longer used in the database once a fresh
discovery process is finished. This will also eliminate all the unwanted objects on the
exported BACnet database.

Once the controllers have been discovered, right hand click on one of the controllers and
click “select all”. Next, click on the “Quick Add” button to add the controllers to the
database of the wireless network.