Viconics VWG-50 (Classic ZigBee) Design Consideration and Setup Guide - Manual (Page 19)

19 | VWG-50-Setup Guide
VWG Zigbee™ Settings
These settings are where you set the Zigbee™ PAN ID (Personal Area Network
Identification) address and the channel for the wireless network
.
 Gateway Wireless PAN ID. (Personal Area Network Identification). This is
where the PAN ID of the gateway is set. Range is from address 1 to 500. The
default of “0” is not a valid PAN ID.
 Wireless Channel. This is where the current Channel frequency used by the
gateway is set. Range is from 11 to 26. (2405 MHz to 2480 MHz, 5 MHz channel
spacing) Please note that channel 26 is attenuated by 4 db compared to the
other channels. The default of “10” is not a valid Channel.
 Viconics highly recommends the use of 802.15.4 channels 15 & 25 only.
802.11 Wi-Fi transmissions overlap and “may” interfere with other channel
selection allowed by 802.15.4 (Channels 11 to 14 & 16 to 24).
General Parameters
 Conversion Units. Use this function prior to the addition of controller s to the
BACnet database. This allows setting the desired exposed temperature analog
variables of the selected controllers to be exposed either in degree Celsius or
degree Fahrenheit scale with the proper unit attribute attached to the objects.
English sets the units to degree Fahrenheit. Metric sets the units to degree
Celsius.