Viconics VWA5000 (Classic ZigBee) Installation Guide - Manual (Page 10)

10 | VWA 5000 Series-Installation Guide
I
MPORTANT
N
OTES
B
EFORE
S
TARTING
P
AIRING
P
ROCEDURE

Verify that the following parameters on the VTR7300 controller are set correctly to
avoid failure in associating the wireless switch to the controller. For more information
on the list of parameters, refer to the VTR7300 controller installation manual.
PAN ID
Personal Area Network
Identification
Default value = 0
Range is: 0 to 1000
This parameter will only appear when a wireless
network adapter is present. If the Terminal Equipment
Controller is installed as a stand-alone unit or with a
BACnet™ or Echelon™ adapter, this parameter will
not be used or displayed.
The default value of 0 is NOT a valid PAN ID.
The valid range of available PAN ID is from 1 to 1000.
Range 1 to 500 for centralized networked applications
using a VWG or a Jace with the wireless stat driver.
Range 501 to 1000 is for stand-alone applications
where no VWG or Jace with the wireless stat driver is
used.
Channel
Channel selection
Default value = 10
Range is: 10 to 26 This parameter will only appear when a wireless
network adapter is present. If the Terminal Equipment
Controller is installed as a stand-alone unit or with a
BACnet™ or Echelon™ adapter, this parameter will
not be used or displayed.
Viconics recommends using only the usage of
channels 15 and 25 only.
The default value of 10 is NOT a valid channel. The
valid range of available channel is from 11 to 26.