Vacuum controller cvc 3000 – VACUUBRAND PC 3012 VARIO User Manual
Page 26
Documents are only to be used and distributed completely and unchanged. It is strictly the users’ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999164 / 19/05/2009
Vacuum Controller CVC 3000
After switching on the device the
version number of the software is displayed, then the preselected
function with the pressure reading.
Attention: Do not cant when assembling or removing plug connections! Comply with correct
orientation of the plug. To connect further components use Y-adapters and extension cables
VACUU•BUS. When connecting an external pressure transducer, it is used automatically. Further
information on how to use several sensors simultaneously is available on request.
When switching on the controller CVC 3000 for the very first time, a menu to select the language of the
controller menu is displayed. Select the desired language e.g., ”English” by turning the selection knob
and press to confirm. Then select the pressure unit (”mbar”, ”Torr” or” hPa”) in the same way.
It is possible to access the language selection menu at any time by switching on the controller
while keeping the selection knob pressed.
Keys
Start or Stop of the control
Venting:
• Short pressing vents short-time, control continues.
• Pressing longer than 2 seconds vents the system to
atmospheric pressure, control stops.
• Selecting menu „function“
• Temporary switching during operation to other functions
Selection knob
• Press to reach the set-up menu of the function
• Turn to reach the parameter set-up
• Press to reach the set value
• Turn to change the set value
• Press to confirm and to reach further parameters or to leave the set-up menu
on/off switch