Top Flite Sierra 40 Trainer Kit - Manual (Page 33)

33
AILERON HOOKUP
6. Cut away the bottom wing skin as shown
to provide an aileron lead exit. Use medium CA
to glue the aileron servo tray (with servo) in its
place as shown on the plans.
Nylon Swivel Clevis Nylon Swivel
7. Hook up the nylon swivel clevises to the
nylon swivels. Thread a 12" threaded end rod
into each swivel clevis. Screw these assem-
blies onto the aileron torque rods down to the
height shown on the "Cross Section At
Centerline: (See the photo at step 9.)
8. Mark the locations for the Z-bends in the
aileron pushrods by holding the ailerons neutral
with tape and putting marks on the pushrods
even with the holes in the servo wheel.
NOTE: When attaching the Z-bends to the
servo wheels, you'll need to use a 5/64" drill
to enlarge the holes in the servo wheels.
Make the Z-bends as shown in the following
sequence.
9. Hook up and make final adjustments to
the aileron linkage.