Top Flite TOPA0965 - Manual (Page 24)

24
INSTALL THE COCKPIT AND REMAINING
SCALE DETAILS
❏
1. Glue the black plastic cockpit fl oor to the fuselage.
❏
2. Locate the two instrument panels. Cut out the
instrument panel from the decal sheet. Place the
decal in place on the back of the instrument panel. The
instruments are not placed symmetrically so there is
a front and back side of the instrument panel. Once
you have determined which is the back side of the
instrument panel, glue the decal of the instruments
to the back side of the panel.
❏
3. Locate the plastic instrument panel housing and
glue the instrument panel into it.
❏
4. Glue the front instrument panel in place in the
front of the cockpit.
❏
5. Temporarily place the turn-over post in the
center of the cockpit. Measure from the base of the
instrument panel back 4-1/4" [107mm]. This is where
the front legs of the post should be glued. Glue the
turn-over post in place at that position
❏
6. Glue the rear instrument panel, seat backs and
pilots in place as shown.