Top Flite TOPA0965 User Manual
Page 13
13
INSTALL THE RETRACTABLE LANDING GEAR
AND WHEELS
❏
1. This step is recommended but optional. Mix a
small amount of epoxy and thin it 40% with alcohol.
Brush the epoxy into the cavity of the wheel area to
fuel proof inside the wing. You could also choose to
do this with a high-quality black paint to fuel proof it
and give it a more fi nished look.
❏
2. Install your retract servo between the mounting
rail in the wing center section using the hardware that
came with the servo.
❏
❏
3. Position the landing gear onto the landing
gear rails as shown here. With a pencil or fi ne tip
marker, mark the location of the holes for mounting
the retracts.
❏
❏
4. Remove the set screw from each side of
the landing gear mount. Apply a couple of drops of
thread locker onto the set screw. Then re-insert it and
tighten it against the landing gear wire. Do this for
both gear.
❏
❏
5. On the marks you made for the location of the
landing gear drill a 1/8" [3mm] hole through the rails.
Do not drill through the top of the wing! Insert and
remove a #6 x3/4" [19mm] screw into each of the
holes. Apply a couple drops of thin CA into the holes
to harden the threads. Allow the glue to harden.
❏
❏
6. Locate one of the 6" [152mm] wires with the
“Z” bend on the end. Insert the end with the “Z” bend
into the connector on the end of the retract unit.