beautypg.com

Warning, Installing to a ceiling – Toa HY-1500HW User Manual

Page 4

background image

When installing the safety wire, be sure to follow the instructions below.
Failure to do so may cause the speaker to fall off, resulting in personal
injury.

• Use a wire rope of 2 mm (0.08") or more in diameter. (The safety wire is not supplied.)
• Tighten the safety wire to take up the slack. Otherwise, impact shock at speaker fall may cause the wire-

connected parts or wire itself to break.

• Install the safety wire to a place that can structurally support the full weight of load.
• Screw a speaker suspension bolt (M8) into one of the screw holes on the speaker's bottom surface.

Then, connect the safety wire to the bolt.

4. INSTALLING TO A CEILING

The brackets to be used are as follows.
For vertical speaker installation:

V-Series Mounting Brackets (HY-1200VB, HY-1200VW, HY-1500VB and
HY-1500VW)

For horizontal speaker installation: H-Series Mounting Brackets (HY-1200HB, HY-1200HW, HY-1500HB and

HY-1500HW)

The example here shows the installation procedure of the mounting bracket using the HS-1200 series speaker
system.

4.1. Using the H- or V-Series Mounting Bracket Only

Step 1. Attach the supplied bracket holder to the speaker.

Fix the bracket holder using the supplied 2 screws (M6 x 20)
after aligning its datum line with the positioning mark (

) on

the speaker system.
Follow the same installation procedure to the other side.

4

Installation position of an M8 bolt
M8 (Screw pitch: 1.25 mm, effective depth: 24 mm)

Note: Unified inch screws cannot be used.

Speaker's
bottom surface

Changing the orientation of
the front panel logo

Turn the logo mark while holding its edges
to change its orientation.

3. SAFETY WIRE INSTALLATION (For speaker fall prevention)

When mounting the speaker system to the ceiling or wall, install a safety wire as needed.

Positioning mark
(on the speaker system)

Datum line
(on the bracket holder)

1-1. For vertical speaker installation (V-Series Mounting Bracket)

Speaker direction angle can be adjusted from 15° upward to 90° downward.

Note
The screw tightening positions differ depending on the speaker's vertical angle as shown below.
The angle is given with reference to the horizontal axis (0°).

Bracket holder
(accessory)

Machine screw M6 x 20 (accessory)

• 15° upward to 60° downward

Adjustable speaker direction angle

• 75° to 90° downward

WARNING