Toa HY-1500HW - Manual (Page 11)

11
Step 3. Install the mounting bracket on the wall.
For the dimensions of the mounting bracket, refer to p.14, "Dimensional Diagrams."
The following figure shows an example of the V-Series Mounting Bracket installation.
Step 4. Install the speaker to the mounting bracket.
Insert the loosely fitted bolts in Step 2 into the
mounting bracket's notches until the bolts fit in at
the end.
The figure at right shows an example for the
speaker system installation to the V-Series
Mounting Bracket.
Similarly, the speaker system can be installed to
the H-Series Mounting Bracket.
Step 5. Connect the speaker cable to the speaker system.
Step 6. Adjust the speaker direction.
Speaker direction can be adjusted is within the range of 15° upward to 60° downward for both the V-
and H-Series Mounting Brackets.
Determine the speaker angle in the way that the screw hole in the bracket holder matches with the angle
adjustment hole in the mounting bracket, then fix the speaker using the supplied hex bolt (M6 x 30).
Follow the same installation procedure to the other side.
6-1. For the V-Series Mounting Bracket
WARNING
Note on bracket mounting
Do not use these 4 round holes.
Use these 4 oval holes to install the
bracket on the wall.
Mounting bracket
Up To the wall surface
Ensure that the notch in the bracket points upward.
Mounting bracket installed on the wall
Loosely fitted bolt in Step 2
15°
60°
7.5°
10 × 7.5° (75°) 0° (Horizontal)
Hex bolt M6 x 30
(accessory)
Wall
Angle adjustment hole
The speaker angle is adjustable in 7.5° steps with
the angle adjustment hole in the mounting bracket.
Bolts and nuts used to fix a bracket on a wall are not
included. Prepare those that are appropriate for the wall's
structure and composition. Failure to do so may cause the
unit to fall, resulting in personal injury.