Toa HY-1500HW - Manual (Page 13)

13
Step 1. Attach the supplied bracket holders and hex bolts to the speaker.
For the procedures, refer to Steps 1 and 2 in the "Using the H- or V-Series Mounting Bracket Only" on
page 4.
Step 2. Attach the Bracket B of the HY-W0801 or HY-W0801W to the H- or V-Series Mounting Bracket.
Be sure to use the hex bolts supplied with the HY-W0801 or HY-W0801W, and the nuts for M8 and
plain washers for M8 supplied with the H- or V-Series Mounting Bracket.
Step 3. Remove the safety bolt from the Bracket A.
Step 4. Install the Bracket A on the wall using 6 bolts.
Step 5. Insert the bolt on the bracket B into the notch in the Bracket A so that the notch is positioned between
the fixed nut and plain washer on the bolt.
Step 6. Run the safety bolt through the holes in the Bracket A, then tighten the bolt using the nut for M8.
Step 7. Mount the speaker to the H- or V-Series Mounting Bracket, then adjust the speaker direction.
For the speaker installation, refer to Steps 4 - 7 in "Using the H- or V-Series Mounting Bracket Only"
on page 6.
After adjusting the horizontal angle, tighten the horizontal angle adjustment nut on the Bracket B.
HY-1500 Series Brackets' adjustable angle range (shaded area)
Bolts and nuts used to fix the Bracket A on a wall are not
included. Prepare those that are appropriate for the wall's
structure and composition. Failure to do so may cause the
unit to fall, resulting in personal injury.
WARNING
For the speaker installed view, refer to p. 3, "Examples of wall installation."
Adjustable angle range (shaded area) when
the HY-1500HB or HY-1500HW is used
Adjustable angle range (shaded area) when
the HY-1500VB or HY-1500VW is used
(Viewed from top)
(Viewed from top)
Wall
Wall
Minus (-) direction
Minus (-) direction
Plus (+) direction
Plus (+) direction
Reference (0° )
Reference (0° )
Adjustable vertical angle (degree)
Adjustable vertical angle (degree)
Adjustable horizontal angle (degree)
Adjustable horizontal angle (degree)