Toa VM-3000 Series User Manual
Page 52
52
(5) Function
Assigns a function to the emergency control input.
Note
The "End of line" function cannot be set to the emergency control Input 6.
* Can be set only when all the versions of VM-3000VA firmware, VM-3000E firmware, and VM-3000
Setting Software are 2.00 or later.
(6) Contents
•
Cannot be used when "Disable" or "Emergency Reset" has been selected in (5) Function settings.
•
Used to set broadcast zones or broadcast stop when "Evacuation EV" or "Alert EV" has been selected in
(5) Function settings. Only the zones registered in the Zone Settings
can be set. When
“Disable” is selected, the EV message is not broadcast though the system is placed in emergency mode.
* Can be set only when all the versions of VM-3000VA firmware, VM-3000E firmware, and VM-3000
Setting Software are 2.00 or later.
•
If "End of line" has been selected in the Function settings (5), select the output of the VM-
3000VA/3000E.
* Can be set only when all the versions of VM-3000VA firmware, VM-3000E firmware, and VM-3000
Setting Software are 2.00 or later.
(7) Control Output
•
Cannot be set when "Disable," "Emergency Reset," "Amplifier cut off," or "End of line" has been selected
in (5) Function settings.
•
If " Evacuation EV" or "Alert EV" has been selected in the Function settings (5), one emergency status
output equipped with each VM-3000VA/3000E can be interlocked.
Selecting the unit designates the emergency status output to interlock.
* Can be set only when all the versions of VM-3000VA firmware, VM-3000E firmware, and VM-3000
Setting Software are 2.00 or later.
Available Settings
Disable (default), Evacuation EV, Alert EV, Emergency Reset, Amplifier cut off*,
End of line*
Available Settings
Disable (default), Zone 1 – 90, STOP*
Available Settings
VA - OUTPUT1 - 6*, E# - OUTPUT1 - 6* ("#" is an ordinal number)
Available Settings
Disable (default), All*, VM-3000VA*, VM-3000E (#)*
("#" is an ordinal number)
(4) Name
Sets the name for the emergency control input.
Available Settings
16 alphanumeric characters (default name: "VA-EMERGENCY-CI*" for the VM-
3000VA and "E#-EMERGENCY-CI*" for the VM-3000E, in which "#" is an ordinal
number and "*" is the terminal number.