Toa VM-3000 Series User Manual
Page 49
49
(5) Contents 1
•
Used to set broadcast zone when "VA - Input 1 - 4" or "EV1 - 6" has been selected in (4) Function
settings.
When a broadcast zone is selected, only the zones registered in the Zone setting
can be set.
* Can be set only when all the versions of VM-3000VA firmware, VM-3000E firmware, and VM-3000
Setting Software are 2.00 or later.
•
Cannot be used when "Disable," "Power ON/OFF," "Failure Receipt," "Failure output reset," or "External
failure input" has been selected in (4) Function settings.
(6) Contents 2
•
Set the control output to be activated in synchronization with broadcasts when "VA - Input 1 - 4" or "EV1 -
6" has been selected in (4) Function settings. The control outputs of the VM-3000VA (refer to
page 32; "Control output settings"
System settings can be set.
•
Cannot be used when "Disable," "Power ON/OFF," "Failure Receipt," "Failure output reset," or "External
failure input" has been selected in (4) Function settings.
Available Settings
Disable (default), VA-GENERAL-CO* and E#-GENERAL-CO*" in which "#" is an
ordinal number and "*" is the terminal number.
Available Settings
Disable (default), Zone 1 – 90, VA-OUTPUT1-6*, E#-OUTPUT1-6* ("#" is an
ordinal number)
(4) Function
Sets the function.
When a sound source is selected, only the sound source with priority level set for 1 – 6 in the general
broadcast sound source priority settings
Note
In the case of the VM-3000E having the local input, this function is fixed. (Refer to
* Can be set only when all the versions of VM-3000VA firmware, VM-3000E firmware, and VM-3000
Setting Software are 2.00 or later.
Available Settings
Disable (default), VA-Input 1 – 4, EV1-6, Power ON/OFF*, Failure Receipt*, Failure
output reset*, External failure input*