Toa VM-3000 Series - Manual (Page 21)

21
6.5. End of Line (EOL) Unit Settings
The EOL unit installed at the end of speaker line monitors the presence or absence of a 40 Hz pilot tone from
the VM-3000. If the line failure occurs, contact information is sent from the EOL to the VM-3000’s emergency
control input, informing the VM-3000 of the abnormality condition.
(The VM-3000’s emergency control input should be set. See
page 51 , Emergency Control Input Settings.)
If the End of line setting is changed on the system setting screen, the emergency control input should also be
changed.
Set the End of line item to “Each output” on the system setting screen as shown below.
Notes
• This function can be used only when all the versions of VM-3000VA firmware, VM-3000E firmware, and
VM-3000 Setting Software are 2.00 or later.
• Both of external attenuators (refer to page 19) and the EOL unit cannot be used together in the same
system.
Note
The following dialog is displayed after the EOL setting completion. Click “Yes,” then perform the emergency
control input setting in the Event settings referring to
page 51 .