Toa M-9000M2 CE-AU - Manual (Page 33)

33
6.7. ZP (Zone Paging) Settings
Click the "ZP Setting" button of the desired channel on the Main view (FISHBONE) screen.
Settings are possible for channels using the ZP-001 module.
The selected button is highlighted.
Step 1. Select the desired ZP operation mode.
MANUAL: Designates individual call zones each time a paging call is made.
AUTO:
Makes a call to the zone(s) preprogrammed in the Paging Call setting.
GROUP: Designates call groups preprogrammed in the Paging Call settings each time a paging call
is made.
Note
For paging zone settings, please refer to "Paging Settings" on
page 47 .
Step 2. Select the paging MODE ("PAGING PORT" or "RING SIGNAL").
Step 3. If a pre-announcement tone is required, click its checkbox.
Step 4. Set the call timeout interval (CONNECT TIME) to "30 seconds"or "10 minutes."
Note
Paging calls exceeding the set timeout interval are automatically cut off.
ZP settings