Toa TS-900 Series - Manual (Page 20)

20
6.3. Voting
Step 1. Place the system in voting mode.
On the Central unit, hold down the Voting Start/End button for 1 second or more. On the Chairman
Unit, simultaneously press Voting keys [1] and [2] for 1 second or more.
The Voting Result display (1 – 3) on the Central unit, and the Voting Status indicators on the
Chairman and Delegate units flash, enabling voting.
(In this event, the Voting Result Display shows [-- -- 0].)
Only a priority speech can be initiated by the Chairman unit during voting operation, and the currently
used microphones of all other units are turned off.
Step 2. Vote.
Press the desired Voting key on the Chairman or Delegate unit,
and the corresponding Voting Status indicator lights.
(Other Voting Status indicators remain flashing.)
Pressing another Voting key invalidates the previously pressed
key, and makes the last pressed key valid. In this event, the
Voting Result display on the Central unit shows the total number
of units whose Voting key was pressed.
Step 3. Terminate voting.
Again hold down the Voting Start/End button on the Central unit
for 1 second or more or alternatively the Chairman unit's Talk key.
Voting operations from the Chairman and Delegate units are
confirmed and Voting Status indicators [1] through [3] extinguish.
The result of computed votes is displayed on Voting Result
displays [1] through [3] on the Central unit.
Note
If voting operation was activated by the Central unit, this operation cannot be terminated by the
Chairman unit. However, if it was activated by the Chairman unit, it can be terminated by the Central
unit as well.
Step 4. Clear the Voting Result display.
Press the Voting Start/End button on the Central unit for 1 second or more once again. The display
contents are cleared from the Central unit's Voting Result display.
(inside of the cover)
Voting activation
switch
TS-901
bottom surface
OFF
OFF
RESET
CHIME MUTE
ON
PRIORITY
RESTORE
ON VOTE
ON
1
2
3
Voting can be started and terminated from the Central unit
or the Chairman unit.
To perform this operation from the Chairman unit, set the
Voting Activation switch to ON as shown in the figure.
(This switch is factory-preset to the OFF position.)
3 2 1
VOTING
START/END
(For the Central unit)
Voting result display
Hold down this button
for 1 second or more.
Voting status
indicators
(For the Chairman unit)
Hold down these keys
for 1 second or more.
Flashes
Lights
(Example)
(For the Chairman unit)
TALK PRIORITY
Hold down this key
for 1 second or more.