Toa TS-800 Series - Manual (Page 33)

33
Attaching a CC-4900 BNC Plug to the 3C-FB Cable
Step 1. Strip the jacket 10 mm from the end of the
coaxial cable.
Step 2. Slip the tube supplied with the BNC plug over the
jacket.
Step 3. Unravel the braided shield and turn it back, then
peel away the aluminum cladding.
Step 4. Strip the dielectric 4 mm from the cable end.
Step 5. Disassemble the BNC plug as shown in the
figure at right.
Step 6. Insert the coaxial cable into the clamping fixture.
Step 7. Insert the clamping fixture assembly into the plug
and then solder the conductor.
Step 8. Insert the plug into the BNC connector.
Step 9. Clamp the connector by tightening the clamping
fixture.
Braided shield
Aluminum cladding
Conductor
10 mm
4 mm
Dielectric
BNC connector Clamping fixture
Clamping fixture Plug BNC connector
BNC connector
Clamping fixture
Solder.
Conductor
(Finished)
Tube