Toa TS-800 Series - Manual (Page 15)

15
DELEGATE UNIT TS-802
TALK
POWER
1
2
3
4
5
6
7
5.3. Delegate Unit TS-802
[Top]
1. Monitor speaker
Speech input from other Chairman or Delegate
units and the Central unit is output from this
speaker.
Use the right-side Monitor Volume Control (10) to
adjust the volume. No sound is output from the
speaker of the unit in use while speaking.
2. Microphone
Use either the TS-903 (Standard) or TS-904
(Long) dedicated microphone.
3. Microphone in-use indicator
Lights when the microphone is turned on (for
speech) and flashes when the battery level is low.
4. Infrared emitter/detector
The device used to transmit and receive infrared
communication signals is built inside this panel.
Note
Never place any object that could block infrared
signal access to this part of the unit, as this would
prevent the unit from transmitting or receiving its
required infrared signal.
5. Speech indicator
Remains lit while the microphone is in use (during
speech). The indicator flashes when the unit is out
of the communications service area.
6. Talk key
When this key is pressed, both the Microphone In-
Use indicator (3) and the Speech indicator (5)
light, and the microphone turns on. Pressing this
key again extinguishes both indicators and turns
off the microphone.
7. Power indicator
Lights when the power is switched ON.
This indicator also flashes when the battery level
is low or the unit is outside the communications
service area.
Note
No microphone is supplied with the TS-802 Delegate unit.