Toa TS-800 Series User Manual

Page 32

10.5.2. Coaxial cable processing

Note: Purchase both the coaxial cable and the required BNC plugs separately.

Follow the procedure below to attach the BNC connector to the coaxial cable:

Attaching a YA-641 or CC-4901 BNC Plug to the 3C-FB Cable

Step 1. Strip the jacket 10 mm from the end of the

coaxial cable.

Step 2. Slip the tube supplied with the BNC plug over the

jacket.

Step 3. Unravel the braided shield and turn it back, then

peel away the aluminum cladding.

Step 4. Strip the dielectric 4 mm from the cable end.

Step 5. Disassemble the BNC plug as shown in the

figure at right and turn the screw on the plug so
that it loosens partially but remains in position.

Step 6. Insert the coaxial cable into the clamping fixture.

Step 7. Insert the clamping fixture assembly into the

plug.

Step 8. Tighten the screw and then clamp the plug by

tightening the clamping fixture.

Tube

Braided shield

Aluminum cladding

Conductor

10 mm

4 mm

Dielectric

Plug

Screw

Plug

Clamping fixture

Screw

Clamping fixture

(Finished)

Coaxial cable

Applicable BNC plug

3C-FB and 5C-FB

YA-641 (1 piece per package), CC-4900 (10 pieces per package),
and CC-4901 (10 pieces per package)

7C-FB

YA-642 (1 piece per package)