TeeJet 844 Sprayer Control - Manual (Page 36)

34
Features
PRINTING
Optional printers are available for printing a spraying report directly from the 844.
This printing feature is only available on 844 consoles that have been upgraded
with the communications package. The optional printers and 844 communications
package are available through your TeeJet supplier.
The printout that you get from the 844 contains memory information that the 844
collects. A sample of this printout is below.
To set the 844 for printing, advance to the last step of the System Setup mode
and select “Prt” for the communications mode. This must only be done once.
Next, connect the printer to the 844 and make sure that the LED’s to the printer
are lit indicating that the printer has power. Simultaneously, depress and hold the
and keys for three seconds or until the printer begins printing. When the
printer is finished, the area and volume counters in the lower right of the display
will be reset to zero.
Disconnect the printer and continue spraying activity if necessary.
Warning: Each time you print, the area and volume counters are reset to
zero. If you do not have the printer connected and have programmed the
844 for printing capability and you are resetting the area and volume
counters, the 844 console will be locked for a short period of time. The 844
is trying to print and is dumping the memory information to the printer
port. When the 844 has finished dumping the information, the display will
return to normal.
NOTE: Printing is only available to 844 consoles that have been upgraded
with the communications package.