TeeJet 844 Sprayer Control - Manual (Page 14)

Connecting Component Cables to Console
Now that you have the console installed you can begin connecting it to the other
components of the 844 system. The standard kit contains a valve end cable that
attaches to the boom control valves and the pressure regulating valve on one
end, and directly to the lower right cable lead of the 844 on the other end. The
valve end cable can be identified as the one with a single connection plug on
one end and either 5 or 7 single wires and one small two wire connector on the
valve end.
A second cable connects the flow meter and/or pressure sensor, and a magnetic
wheel speed sensor, proximity speed sensor or radar speed sensor to the 844
console. It attaches to the sensor cable connector located on the top of the right
side of the controller. The correct cables will be supplied with the 844 kit you
ordered or purchased.
Lay out the cables before installing the sprayer components to be sure the cables
are long enough. Each of these cables is 15 feet (4.5 meters) in length from the
sensor connections to the 844 console connection. If your installation requires
longer cables, an 8 or 15 foot (2.5 or 4.5 meter) extension that installs between
the console and the standard end cable is available.
If an exit hole had to be cut in the cab, be sure the edges are deburred and
protected to prevent damage to the cables.
12
4
CONSOLE
S T E P
SENSOR CABLE
LEAD
POWER CABLE
LEAD
VALVE CABLE
LEAD