TeeJet TASC DATA LOGGER User Manual

Page 17

MIDWEST TECHNOLOGIES, INC.

SPRINGFIELD, ILLINOIS 62703

TASC DATA-LOGGER-R1

PN - 999-1522

Turn the paper roll so as to take up any slack in the paper feeding to the printer and replace
the clear plastic cover. Make sure the roll of paper turns freely. If it does not turn freely, the
paper will jam and will possibly damage the printer mechanism.

TO REMOVE THE PAPER ROLL:

First use the paper TEST switch to advance the paper about one inch beyond the paper cutter. Now lift the
paper roll away from the printer housing. Cut the paper feeding into the printer with scissors. Try to make the
cut as square as possible to facilitate the next reloading of paper. You may now pull the remaining paper
through the printer mechanism. Be sure to pull the paper from the front (paper cutter side).

WARNING! Pulling the paper out of the back of the printer will damage the print mechanism.

PRINTER SELF TEST:

You can test the print head and ribbon ONLY AFTER INSERTING PAPER. DO NOT TEST WITHOUT
PAPER. To perform the test follow these steps:

Assure ON/OFF switch is in the OFF position, then apply power to the DATA-LOGGER.

Depress the ON/OFF switch to the paper TEST position.

Hold switch in paper TEST position until LED light goes on and printer starts to operate.

Stop the Self Test by turning the ON/OFF switch to OFF. Wait about 3 seconds and
depress the ON/OFF switch to ON. The printer is now ready.