TeeJet TASC-6500 - Manual (Page 8)

TASC 6200/6500 999-1511
M-T 96162 8
TASC-6500
CHEMICAL APPLICATORS
1 2 3
ON
OFF
Alt.-
RATE
%Rate
DISPLAY SELECTOR
Speed
Area Width
Distance
Vol. Applied
Test
Speed
Fan RPM
Vol. Applied
Appl. Rate Appl. Rate
OFF SET- UP DEC
ON OPERATE INC
.
1 2 3 4 5 6 7 8 9
BOOMS
Scan
MID-TECH
¨
MIDWEST TECHNOLOGIES,
INC.
RATE CONTROL CHANNELS
L & CHEMICALS CARRIER
Mph
L C
2.1 POWER SWITCH
The power switch controls power to the console. Turn power OFF when not in use. The console has a
nonvolatile memory so it will remember the constants and data previously entered, even if the vehicle
battery goes dead.
2.2 MODE SELECTOR " OPERATE/SET-UP " SWITCH
The mode selector switch selects between the operate mode and the set-up mode. This switch must be
in the operate position to begin applying. The set-up position is used for entering information to the
console. Anytime an incorrect switch setting is selected, an Err message will appear.
2.3 THE INC/DEC SWITCH
The INC/DEC switch is used to change values appearing in the display. This switch is also used to zero
accumulated data and to select special programming modes for the console.
2.4 THE DISPLAY SELECTOR SWITCH
The display selector switch is used to select and display the different console functions. It will display
different things depending on the mode selector switch setting. The following table will explain the
functions appearing for each display selector switch setting. Anytime an incorrect switch setting is
selected, an Err message will appear.
2.0 SWITCHES AND CONTROLS
The figure below shows the switches and displays on the TASC Spreader Control.
CHEMICAL APPLICATOR
RATE SWITCHES
CHANNEL L
AND C RATE
SWITCHES
DISPLAY
SELECTOR
SWITCH
INCREASE/DECREASE
SWITCH MODE SELECTOR
SWITCH
POWER
SWITCH
DISPLAY
BOOM INDICATORS