Casio fx-9750G PLUS - Manual (Page 406)

378
2. Since the condition comes after the While-statement, the condition is tested
(checked) before the commands inside the loop are executed.
Example: 10 → A_
While A > 0_
A – 1
→ A_
”GOOD”_
WhileEnd
k k k k k Program Control Commands (CTL)
Break
Function: This command breaks execution of a loop and continues from the next
command following the loop.
Syntax: Break _
Description:
1. This command breaks execution of a loop and continues from the next
command following the loop.
2. This command can be used to break execution of a For-statement, Do-
statement, and While-statement.
Example: While A>0_
If A > 2_
Then Break_
IfEnd_
WhileEnd_
A ^
← Executed after Break
Prog
Function: This command specifies execution of another program as a subroutine.
In the RUN Mode, this command executes a new program.
Syntax: Prog ”file name” _
Example: Prog ”ABC” _
Description:
1. Even when this command is located inside of a loop, its execution immediately
breaks the loop and launches the subroutine.
2. This command can be used as many times as necessary inside of a main
routine to call up independent subroutines to perform specific tasks.
3. A subroutine can be used in multiple locations in the same main routine, or it
can be called up by any number of main routines.
20- 11
Command Reference