Casio fx-9750G PLUS - Manual (Page 193)

165
Graphing with the Sketch Function
10 - 2
u u u u u To insert text in the RUN or PRGM Mode
The following is the syntax for inserting text in these modes.
Text , , “”
• The line number can be specified within the range of 1 to 63, while the column
number can be specified in the range of 1 to 127.
• The following are the characters that can be used inside of comment text in
the STAT, GRAPH, TABLE, RECUR, or CONICS Mode.
A~Z, r , θ, space, 0~9, ., +, –, Ч, ч, (–), EXP, π, Ans, {, (, ), [, ], {, }, comma, →,
x 2 ,
^
, log, In, , x , 10 x , e x , 3 , x –1 , sin, cos, tan, sin –1 , cos –1 , tan –1
• A newline operation cannot be performed when inserting comment text. To
input multiple lines, you have to perform the above comment text insert
operation more than once.
k k k k k
Turning Pixels On and Off
[Sketch]-[PIXL]
The following procedure lets you turn each individual screen pixel on and off. You
can specify any pixel from the upper left-hand corner (1, 1) to the lower right-hand
corner (63, 127) of the screen.
Line range: 1 to 63
Column range: 1 to 127
• Note that you can turn pixels on and off only in the RUN and PRGM Modes.
When turning pixels on and off, first display the sketch menu and then press 6
(g) 6 (g) 3 (PIXL) to display the pixel menu.
• { On} ... {turns specified pixel on}
• { Off} ... {turns specified pixel off}
• { Chg} ... {switches status of specified pixel}
u u u u u To turn pixels on and off [Sketch]-[PIXL]-[On]/[Off]/[Chg]
• To turn a pixel on
PxlOn ,
• To turn a pixel off
PxlOff ,
• To change the on/off status of a pixel
PxlChg ,