Casio fx-9750G PLUS - Manual (Page 298)

270
18 - 5
Performing Statistical Calculations
18-5 Performing Statistical Calculations
All of the statistical calculations up to this point were performed after displaying a
graph. The following procedures can be used to perform statistical calculations
alone.
u u u u u To specify statistical calculation data lists
You have to input the statistical data for the calculation you want to perform and
specify where it is located before you start a calculation. Display the statistical
data and then press 2(CALC)6 (SET).
The following is the meaning for each item.
1Var XList ....... specifies list where single-variable statistic x values (XList)
are located
1Var Freq ........ specifies list where single-variable frequency values
(Frequency) are located
2Var XList ....... specifies list where paired-variable statistic x values (XList)
are located
2Var YList ....... specifies list where paired-variable statistic y values (YList)
are located
2Var Freq ........ specifies list where paired-variable frequency values
(Frequency) are located
• Calculations in this section are performed based on the above specifications.
k k k k k Single-Variable Statistical Calculations
In the previous examples from “Drawing a Normal Probability Plot” and “Histogram
(Bar Graph)” to “Line Graph,” statistical calculation results were displayed after the
graph was drawn. These were numeric expressions of the characteristics of
variables used in the graphic display.
These values can also be directly obtained by displaying the statistical data list
and pressing 2 (CALC) 1 (1VAR).