Casio fx-9750G PLUS - Manual (Page 216)

188
• Pressing A while the Dynamic Graph is being drawn changes to the drawing
speed setting display. The draw operation is suspended at this time, and you
can view the graph by pressing !6 (G
↔ T).
• Selecting “Cont” and then executing a Dynamic Graph operation causes the
graphing operation to repeat until you press A. Be sure that you do not forget
to stop the Dynamic Graph operation after you are finished. Allowing it to
continue will run down the batteries.
k k k k k
Stop & Go Drawing
By selecting “ STOP & GO ” as the graph drawing speed, you can draw graphs
one by one. A graph is drawn each time you press w.
Example To use Stop & Go to draw the same graph that you drew in the
previous example (page 184)
1. Display the coefficient value specification display and press 3 (SPEED).
2. Use f and c to select “ STOP & GO ( )” and press 1 (SEL) J.
3. Start drawing of the Dynamic Graph.
6 (DYNA)
w
··· →
←···
w
• Pressing A while the Dynamic Graph is being drawn changes to the drawing
speed setting display. The draw operation is suspended at this time, and you
can view the graph by pressing !6 (G
↔ T).
k k k k k
Overwriting
By turning “ On” the locus (Locus) setting of the Dynamic Graph, graphs are
sequentially drawn on the same display. The newest graph drawn is easily
identifiable because its color is different from graphs that were previously on the
display.
Example To switch the locus setting on and draw the same graph that
you drew in the previous example (page 184)
1. Display the coefficient menu. Next, display the set up screen and specify “ On”
for Locus and then press J.
13 - 3
Drawing a Dynamic Graph
CFX