Removing the hard disk drive, Hard disk upgrade process, Removing the hard disk drive -6 – Clevo M860TU User Manual

Page 32

Disassembly

2 - 6 Removing the Hard Disk Drive

2.Disassembly

Removing the Hard Disk Drive

The hard disk drive is mounted in a removable case and can be taken out to accommodate other 2.5" serial (SATA) hard
disk drives with a height of 9.5mm (h). Follow your operating system’s installation instructions, and install all necessary
drivers and utilities (as outlined in Chapter 4 of the User’s Manual) when setting up a new hard disk.

Hard Disk Upgrade Process

1. Turn off the computer, and turn it over and remove the battery (

page 2 - 5

2. Locate the component bay cover and remove screws

3. Carefully (a fan and cable are attached to the under side of the cover) lift up the bay cover

4. Carefully disconnect the fan cable

, and remove the cover

5. The hard disk assembly cover will be visible at point

on the mainboard.

Figure 2

HDD Assembly

Removal

a. Remove the screws.
b. Remove the cover and lo-

cate the hdd.

8. Component Bay

Cover

• 7 Screws

Fan Cable

Make sure you recon-
nect the fan cable
before screwing down
the bay cover.