Solvline SG-3011PCL User Manual
Page 34
SerialGate User Manual
34
If the it need to be set as low for pin 1, use the ’10.’. Command. If the above command is
successfully processed, ‘O’ will be displayed to show OK. If the command returns an error, ‘E’
will be displayed.
Now that PB6 pin 1 value is set to ‘high’, PB5 pin 0 can output its value which is 1. When ‘0-’
command is entered, the following value will be displayed.
If the command syntax is in wrong format, or the value is not correct, an ‘E’ will be displayed
which stands for ‘error’.