Solvline SG-3011PCL - Manual (Page 23)

SerialGate User Manual
23
GPIO Setting
From GPIO menu, GPIO related settings can be modified.
Information displayed in the ‘GPIO’ page is show below.
Menu Default Description
Direction In
Set the direction of the GPIO.
In: Set GPIO pin to receive only mode.
Out: Set GPIO pin to send only mode.
Value Low
Set the output value from the pin.
Low (0): Set the output value to low (zero).
High (1): Set the output value to high (one).
Pull Up
/
Pull Down
No
Enable using the terminating resistor.
No: Disable use of the terminating resistor.
Pull Up: Enable the pull up resistor.
Pull Down: Enable the pull down resistor.
TCP Port 5000
By using TCP Client mode from other devices, the users can
connect to SG-3011PCL and modify the configuration values or test
the device. The port number to connect to this device is specified
here.
For more information about the commands, to modify the
configuration values or testing the device, please refer to chapter 7.