Solvline SG-3011PCL - Manual (Page 11)

SerialGate User Manual
11
 Serial/Power/GPIO Connector: 2.54mm pin header
 Reset Button: Restarts SG-3011PCL or load the factory default depending on the time it is
pressed. (More information in the can be found below.)
 LED: Shows the status of the SG-3011PCL.
(More information can be found below.)
 LAN (Ethernet) Port: This port, 8-pin RJ-45, is used to connect the SG-3011PCL with the
LAN/Ethernet port in the PC, hub, router, or other wired network device.
LEDs
LED Name State Operation
1 RDY Blink
When the device is powered, it will stay on for a while then
start blinking when booting process is completed.
2
SRL
(Red)
1
Blink
Transmitting/Receiving data
1. RS-422/485
2. RS-232
3. TTL
2
3
3
LAN Port
(Green on Left)
On 100 Base Tx Standard network enabled
Off 10 Base Tx Standard network enabled
4
LAN Port
(Yellow on Right)
On Connected to the network
Off Network disconnected
Blink Transmitting/Receiving LAN data
Reset Switch
Pressed for Description
1 Less than 3 seconds Restarts the SG-3011PCL
2 3 seconds or more Reverts all settings to the factory default values.