Cisco 6500 - Manual (Page 53)

4-53
Cisco IOS Software Configuration Guide, Release 12.2SX
OL-13013-06
Chapter 4 Configuring Virtual Switching Systems
Configuring a VSS
Verifying Injected Routes in a Service Module in a VSS
To view route health injection (RHI) routes, perform this task:
This example shows how to view injected routes in a service module in a VSS:
Router# show svclc rhi-routes switch 1 slot 4
RHI routes added by slot 34
ip mask nexthop vlan weight tableid
--------------- --------------- --------------- ------ ------ -------
A 23.1.1.4 255.255.255.252 20.1.1.1 20 1 0
Viewing Chassis Status and Module Information in a VSS
To view chassis status and information about modules installed in either or both chassis of a VSS,
perform the following task:
This example shows how to view the chassis status and module information for chassis number 1 of a
VSS:
Router# show module switch 1
Switch Number: 1 Role: Virtual Switch Active
---------------------- -----------------------------
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 48 CEF720 48 port 10/100/1000mb Ethernet WS-X6748-GE-TX SAL1215M2YA
2 8 CEF720 8 port 10GE with DFC WS-X6708-10GE SAL1215M55F
3 1 Application Control Engine Module ACE20-MOD-K9 SAD120603SU
.
.
.
Command Purpose
Router# show svclc rhi-routes switch num slot slot Displays injected RHI routes in the specified service
module.
• num—Specifies the switch to access; valid values
are 1 and 2.
• slot—Specifies the slot number of the module.
Command Purpose
Router# show module switch { 1 | 2 | all } Displays information about modules in the specified chassis
(1 or 2), or in both chassis (all).