Displaying vss information, Converting a vss to standalone chassis – Cisco 6500 User Manual
Page 36
4-36
Cisco IOS Software Configuration Guide, Release 12.2SX
OL-13013-06
Chapter 4 Configuring Virtual Switching Systems
Configuring a VSS
Displaying VSS Information
To display basic information about the VSS, perform one of these tasks:
The following example shows the information output from these commands:
Router# show switch virtual
Switch mode : Virtual Switch
Virtual switch domain number : 100
Local switch number : 1
Local switch operational role: Virtual Switch Active
Peer switch number : 2
Peer switch operational role : Virtual Switch Standby
Router# show switch virtual role
Switch Switch Status Preempt Priority Role Session ID
Number Oper(Conf) Oper(Conf) Local Remote
------------------------------------------------------------------
LOCAL 1 UP FALSE(N) 100(100) ACTIVE 0 0
REMOTE 2 UP FALSE(N) 100(100) STANDBY 8158 1991
In dual-active recovery mode: No
Router# show switch virtual link
VSL Status: UP
VSL Uptime: 4 hours, 26 minutes
VSL SCP Ping: Pass OK
VSL ICC (Ping): Pass
VSL Control Link: Te 1/5/1
Converting a VSS to Standalone Chassis
To convert a VSS into two standalone chassis, you perform the following major steps:
•
Copying the VSS Configuration to a Backup File, page 4-37
•
Converting the VSS Active Chassis to Standalone, page 4-37
•
Converting the Peer Chassis to Standalone, page 4-37
Command
Purpose
Router# show switch virtual
Displays the virtual switch domain number, and the
switch number and role for each of the chassis.
Router# show switch virtual role
Displays the role, switch number, and priority for
each of the chassis in the VSS.
Router# show switch virtual link
Displays the status of the VSL.