beautypg.com

Copying the vss configuration to a backup file, Converting the vss active chassis to standalone, Converting the peer chassis to standalone – Cisco 6500 User Manual

Page 37

background image

4-37

Cisco IOS Software Configuration Guide, Release 12.2SX

OL-13013-06

Chapter 4 Configuring Virtual Switching Systems

Configuring a VSS

Copying the VSS Configuration to a Backup File

Save the configuration file from the VSS active chassis. You may need this file if you convert to virtual
switch mode again. You only need to save the file from the VSS active chassis, because the configuration
file on the VSS standby chassis is identical to the file on the VSS active chassis.

Converting the VSS Active Chassis to Standalone

When you convert the VSS active chassis to standalone mode, the VSS active chassis removes the
provisioning and configuration information related to VSL links and the peer chassis modules, saves the
configuration file, and performs a reload. The chassis comes up in standalone mode with only the
provisioning and configuration data relevant to the standalone system.

The VSS standby chassis of the VSS becomes VSS active. VSL links on this chassis are down because
the peer is no longer available.

To convert the VSS active chassis to standalone mode, perform this task on the VSS active chassis:

Converting the Peer Chassis to Standalone

When you convert the new VSS active chassis to standalone mode, the chassis removes the provisioning
and configuration information related to VSL links and the peer chassis modules, saves the configuration
file and performs a reload. The chassis comes up in standalone mode with only its own provisioning and
configuration data.

To convert the peer chassis to standalone, perform this task on the VSS standby chassis:

Command

Purpose

Step 1

Switch-1# copy running-config startup-config

(Optional) Saves the running configuration to startup
configuration. This step is only required if there are
unsaved changes in the running configuration that
you want to preserve.

Step 2

Switch-1# copy startup-config disk0:vs-startup-config

Copies the startup configuration to a backup file.

Command

Purpose

Switch-1# switch convert mode stand-alone

Converts Switch 1 to standalone mode.

After you enter the command, you are prompted to
confirm the action. Enter yes.

Command

Purpose

Switch-2# switch convert mode stand-alone

Converts Switch 2 to standalone mode.

After you enter the command, you are prompted to
confirm the action. Enter yes.