Cisco 6500 - Manual (Page 67)

4-67
Cisco IOS Software Configuration Guide, Release 12.2SX
OL-13013-06
Chapter 4 Configuring Virtual Switching Systems
Upgrading a VSS
Boot Variable = disk0:s72033-oldversion.v1,12;
Operating Mode = sso
Primary Version = N/A
Secondary Version = N/A
Current Version = disk0:s72033-oldversion.v1
Router# show redundancy status
my state = 13 -ACTIVE
peer state = 8 -STANDBY HOT
Mode = Duplex
Unit = Secondary
Unit ID = 18
Redundancy Mode (Operational) = sso
Redundancy Mode (Configured) = sso
Redundancy State = sso
Maintenance Mode = Disabled
Communications = Up
client count = 132
client_notification_TMR = 30000 milliseconds
keep_alive TMR = 9000 milliseconds
keep_alive count = 0
keep_alive threshold = 18
RF debug mask = 0x0
eFSU Upgrade on an Installed Modular Image Example
This example shows how to perform an an eFSU upgrade on an installed modular image:
Router# copy ftp://172.18.108.26/s72033-advipservicesk9_wan-vz.122-33.SXI2
sup-bootdisk:s72033-advipservicesk9_wan-vz.122-33.SXI2.bin
Router# copy ftp://172.18.108.26/s72033-advipservicesk9_wan-vz.122-33.SXI2
slavesup-bootdisk:s72033-advipservicesk9_wan-vz.122-33.SXI2.bin
Router# install file sup-bootdisk:s72033-advipservicesk9_wan-vz.122-33.SXI2.bin sup-bootdisk:/newsys
Router# install file slavesup-bootdisk:s72033-advipservicesk9_wan-vz.122-33.SXI2.bin
slavesup-bootdisk:/newsys
Router# show issu state
Slot = 1/6
RP State = Active
ISSU State = Init
Boot Variable = bootdisk:/sys/s72033/base/s72033-advipservicesk9_wan-vm,12;
Slot = 2/6
RP State = Standby
ISSU State = Init
Boot Variable = bootdisk:/sys/s72033/base/s72033-advipservicesk9_wan-vm,12;
Router# issu loadversion sup-bootdisk:/newsys/s72033/base/s72033-advipservicesk9_wan-vm
%issu loadversion executed successfully, Standby is being reloaded
Router# show issu state
Slot = 1/6
RP State = Active
ISSU State = Load Version
Boot Variable = bootdisk:/sys/s72033/base/s72033-advipservicesk9_wan-vm,12;
Slot = 2/6
RP State = Standby
ISSU State = Load Version
Boot Variable = bootdisk:/sys/s72033/base/s72033-advipservicesk9_wan-vm,12;
Router# issu runversion
This command will reload the Active unit. Proceed ? [confirm]
Router# show issu state
Slot = 2/6