Rev-A-Shelf TANDEM plus BLUMOTION - Manual (Page 2)

For more information about installing Blum products go to www.blum.com
or call 1-800-438-6788 for customer service.
Technical specifications subject to change without notice.
Drawer back preparation
Drawers must have 6 mm holes drilled in
the back panel to accept the hooks on the
TANDEM runners. Drawers must also be
notched in the back, flush with the drawer
sides and drawer bottom.
NOTE: Detailed drawings for recommended
drawer construction are available at
www.blum.com.
13 (1/2")
33 (1-5/16")
Dimensions
Drawer preparation
Bore rear holes Pre-bore for locking devices Attach locking devices
NOTE: Mounting screws must go in at a precise angle and locking device must
sit flat against the drawer bottom to ensure proper function of the drawer
NOTE: Use of the T65.1000.02 TANDEM template is highly recommended
Locking device Screws 612TH
2.5 mm bit with
extension chuck
TANDEM boring
template TANDEM
boring template
6 mm bit with stop collar
Outside drawer width
Waste/recycle set
Drawer
length
Min. inside
cabinet width
For drawer side thickness
16 (5/8") 15 (19/32") 14 (9/16") 13 (1/2") 12 (15/32")
568R5337BB 21" 305 (12") 295 (11-5/8") 293 (11-17/32") 291 (11-15/32") 289 (11-3/8") 287 (11-5/16")
568R5337BD 21" 381 (15") 371 (14-19/32") 369 (14-17/32") 367 (14-7/16") 365 (14-3/8") 363 (14-9/32")
568R5337BF 21" 457 (18") 447 (17-19/32") 445 (17-17/32") 443 (17-7/16") 441 (17-3/8") 439 (17-9/32")
Drawer requirements
7 (9/32")
11 (7/16")
Ø6 x 1 0
bo r e f or hook
13 (1/2")
Drawer preparation and adjustment
Height adjustment
Press up on adjustment tab
Push toward back of drawer
Maximum 3 (1/8") rise of drawer front.
Tilt adjustment
Rotate the tilt adjustment lever on the rear
of each runner to tilt the top of the
drawer front forward.
Tool-free tilt adjustment +5 mm.
1
2
1
2
Drawer removal
1. Squeeze orange release levers on
locking devices
2 Pull drawer out and up
1
2
Removal and adjustment
Part no.
TANDEM template T65.1000.02
Tool set T65.9000
Minimum top
clearance
6 (1/4")
Inside cabinet width
Outside drawer width
Drawer side
thickness
16 (5/8") max.
14 (9/16")
Bottom clearance
Inside cabinet width
Opening height
Bin height +
drawer bottom thickness +
33 (1-5/16”)