Rev-A-Shelf LD-2942-28-11-1 - Manual (Page 4)

4 of 4
System 9
Pie-cut
Doors revolving
90-degree corner
Door Adjustment
1. Door alignment
- Open doors so that one side of the bottom mounting bracket can be
seen. With a pencil, mark the original position of the bottom mounting
bracket. Insert a screw into the large hole on the end of the bracket
(When inserting the screw, place it off-center in the direction of desired
adjustment). Take out the original fixing screw. Repeat on the other side.
- Loosen the screws over the large holes and carefully rotate the bracket
to the left or to the right, depending on which way the doors need to go.
- Tighten the screws and close doors to check alignment.
- Once door alignment is complete, re-insert fixing screws into one of the
small holes.
2. Height adjustment
- * Shipping pin must be removed before attempting height adjustment.
- Rotate doors to the right, exposing the height adjustment screw on the
tube between the top and bottom trays.
- Turn screw to the right to raise the doors, and to the left to lower the doors.
- TRAYS DO NOT NEED TO BE UNLOADED TO ADJUST HEIGHT
(UP TO 120 LBS.)
* Tools required - Phillips screwdriver