PRG DMX Reference Guide 5.4 - Manual (Page 86)

78 DMX512 REFERENCE GUIDE
b. For newer APS6 modules, a four position rotating switch on the face plate sets the output to 400, 625,
or 700 watts (the fourth setting is also currently 400W).
1) Set mode switch to either PSET or DCV.
CAUTION: Do not change mode or wattage with power applied to module.
2) Using 3/32 slot screwdriver (07.3005.0001), rotate power selector switch to required output
according to settings listed on face plate.
Figure 3-31: APS6 Power Selector
Step 4. Configure C3 modules.
The C3 module can be configured in two different output modes to accommodate both the 1000 watt and
1200 watt versions of the 120V incandescent lamps use with the VL5 and VL5B luminaires. The 8.33 mode
is used with 1000W/120V lamps and the 10.0A mode is used with 1200W/120V lamps. A 0W shunt (blue
programming jumper) installed at PCB determines the mode.
a. At PCB, install 0W shunt (blue programming jumper) on header marked 8.33A for 1000W operation or
10.0A for 1200W operation.
Figure 3-32: C3 Module Jumper
Mode Switch
Power Switch
Power Switch Settings
8.33 10.0
JMP 2
Blue Programming
Jumper