PRG DMX Reference Guide 5.4 - Manual (Page 109)

DMX512 REFERENCE GUIDE 101
013 All Async
All tests above will run asynchro-
nously. All motors will reach
respective EOT stop (if applicable)
and begin motion to opposite EOT
stops at each motor’s earliest
opportunity. Motion will not be
coordinated between motor.
Flashing display indi-
cates sensor not hit.
Solid display indicates
sensor hit.
021 Sensors
9 Monitor Lens 3 Sensor
8 Monitor Lens 2 Sensor
7 Monitor Lens 1 Sensor
6 Monitor Strobe Sensor
5 Monitor Fixed Gobo Sensor
4
Monitor Rotating Gobo Wheel,
Wheel position Sensor and Gobo
Orientation Sensor
3 Monitor Plate 2 Saturation Sensor
2 Monitor Plate 2 Color Sensor
1 Monitor Plate 1 Saturation Sensor
0 Monitor Plate 1 Color Sensor
022/
023
Pan/Tilt Encoders
9
Display current most significant
digit (Xxxx) of the reported encoder
value. Repeatedly monitored.
8
Display current most significant
digit (Xxxx) of the reported encoder
value. Repeatedly monitored.
7
Display current most significant
digit (Xxxx) of the reported encoder
value. Repeatedly monitored.
6
Display current most significant
digit (Xxxx) of the reported encoder
value. Repeatedly monitored.
0
Display scrolling snapshot of each
digit of the reported encoder.
Repeatedly monitored.
024 Form and Function 0
Display the form and function value
of the luminaire. For the VL7
Py=F10 should be reported where
Y is the luminaire’s port number.
Table 4-9: VL7B/VL7UB Spot Luminaire Mechanical Tests (Continued)
Test Number Test Parameter Error Codes/Comments