PRG DMX Reference Guide 5.4 - Manual (Page 79)

DMX512 REFERENCE GUIDE 71
To install VL2C sound blanket:
Step 1. At sound blanket, unlatch buckles from straps and buckles from side of baffle shell.
Step 2. At luminaire, place sound blanket shells on luminaire and snap strap buckles.
Step 3. At each side of sound blanket, secure side buckles.
Note: It may be necessary to add a piece of gaffer’s tape at the joint between the two halves to stop the yoke from
catching.
VL4 Sound Baffle
Figure 3-24: VL4 Sound Baffle
To install VL4 sound blanket:
Step 1. Route safety cable through eyelet in sound baffle.
Step 2. Align sound baffle with air intakes.
Note: Because of the baffle's tight fit, it may be necessary to remove the air filters before installation in some cases.
Step 3. Push down bottom flanges of baffle between bottom lips of fan intakes and air filters (if installed).
Step 4. Push up top flanges of baffle between top lips of fan intakes and air filters (if installed).
Step 5. Ensure that baffle fits snugly.
4ECA009