PRG DMX Reference Guide 5.4 - Manual (Page 64)

56 DMX512 REFERENCE GUIDE
Series 200 Hanging Hardware
All Series 200 luminaires and repeaters are provided with truss hooks and a safety cable.
CAUTION: The wing bolt should be tightened only by hand. Do not use wrenches or other tools as this can
damage the truss or the hook.
Single Truss Hook Variations
The Series 200 luminaires (VL2/VL4) and repeaters use the single truss hook. Multiple variations of the hook are
available to accommodate a wide variety of installation configurations.
Figure 3-3: Single Truss Hooks
While the hanging methods for repeaters are limited to either a one- or two-hook hang, luminaires offer greater
hanging flexibility.
Note: Refer to "Series 200 Hanging Methods" on page 57 for hook placement illustration.
The VL2C luminaire has five receptacles for connecting truss hooks.
+ Standard hooks in opposite corners are parallel.
+ Standard hooks in adjacent corners are at right angles.
+ A standard hook in the center receptacle is parallel to two of the corners and at a right angle to the other two.
+ A 90 degree hook is available so adjacent hooks can be parallel.
+ The 45 and 135 degree hooks allow the luminaire to be hung square with the truss pipe.
The VL4 luminaire has four receptacles for connecting truss hooks. Like the VL2C luminaire, standard hooks on
opposite sides are parallel, while standard hooks on adjacent sides are at right angles.
The hook is inserted in the receptacle and turned 90 degrees clockwise to lock. To re-orient the hook 180 degrees,
remove the truss hook, turn it 180 degrees around and re-insert the hook. When installing the truss hooks, never turn
the hook more than 90 degrees, as this will damage the receptacle.
S200 Single
Hook
45 Degree 90 Degree 135 Degree Standard